- Additional information
- Reviews (0)
APM Power Module with XT60 Connector
A battery Eliminator circuit is a type of voltage regulator.it is used to prevent high voltage towards the Esc’s and pass the required voltage which is essential. As modern RC airplanes use high voltage batteries, it allows you to run your receiver, servos, and other accessories from your main battery without using a separate lower voltage one.
The APM 2.5.2/2.6/2.8 Pixhawk Power Module is a simple way of providing your APM 2.5 with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.3V and a maximum of 2.25A from a 2S-6S LiPo battery. The Power Module comes completely assembled with “Deans” or “T” connectors, and wrapped in shrink tubing for protection. Also, the circuit detects a sensing current around 90 A.
- Voltage and current measurement configured for 5V ADC.
- Switching regulator outputs 5.3V and 3A max.
- 6-pos DF13 cable plugs directly to APM 2.5’s ‘PM’ connector.
- Supports from 2 cell to 6 cell battery.
Only logged in customers who have purchased this product may leave a review.
You may also like…
ESP-EYE Dev Kit
₹2,702.00 (incl GST)
₹2,289.83 (+18% GST extra)
Pixhawk PPM Encoder Module
₹507.00 (incl GST)
₹429.66 (+18% GST extra)
Pixhawk PX4 Autopilot PIX 2.4.8 32 Bit Flight Controller
₹8,500.00 (incl GST)
₹7,203.39 (+18% GST extra)
3DR Single TTL MINI Radio Telemetry 433MHz 250mW for PIXHAWK and APM
₹3,500.00 (incl GST)
₹2,966.10 (+18% GST extra)